Every moisture problem has a different source. We identify yours specifically before we quote anything — then we deploy the right system, not the most expensive one.
💧
Interior Drain Tile & Perimeter Channel Systems
When hydrostatic pressure is the primary culprit, the most effective long-term solution is a properly engineered interior drainage system. We install sub-slab perforated drain tile around the perimeter of your basement — capturing water before it can rise above slab level — and route it to a sump pit equipped with a dual-pump configuration.
These systems don't fight hydrostatic pressure — they redirect it.
📞 Get a Free Drainage Quote →
🏗️
Exterior Foundation Coating & Drainage Board Installation
Exterior waterproofing is the most comprehensive solution available — stopping water before it contacts your foundation wall. We excavate to the footing, apply a rubberized polymer membrane to the exterior foundation face, install dimple-mat drainage board, and backfill with clean crushed stone to redirect surface water away from the structure.
We use SilkOate, UMARK, and other commercial-grade membrane systems — not the paint-on damp-proofing that deteriorates within a few years.
📞 Schedule an Exterior Assessment →
🔧
Structural Crack Repair: Injection & Carbon Fiber Stapling
We inject poured-wall cracks using a port-and-backer system: surface ports are installed at 8–12 inch intervals along the crack, the surface is sealed with hydraulic cement, and two-part polyurethane or epoxy is pumped under pressure from the lowest port up — filling the crack through its full depth.
For concrete block foundation walls showing horizontal cracking or inward bowing, we pair crack repair with carbon fiber reinforcement straps anchored at the floor and rim joist.
📞 Get a Crack Injection Estimate →
🌿
Crawl Space Moisture Control: Encapsulation to Full Waterproofing
We install a minimum 20-mil reinforced poly vapor barrier over the entire crawl space floor and seal it up the walls to the sill plate — then seal all vents, install a conditioned air supply or dedicated crawl space dehumidifier, and spec a sump system if groundwater is present.
Encapsulation turns your crawl space from an uncontrolled dirt floor into a semi-conditioned space.
📞 Schedule a Crawl Space Inspection →
⚙️
Sump Pump Installation, Replacement & Battery Backup Systems
The sump pit itself matters as much as the pump. We construct 18-inch diameter pits with a gravel bed at the base for proper water collection, sealed lids to prevent vapor and radon entry, and a discharge line that terminates a minimum of 10 feet from the foundation at a positive-grade daylight point.
For finished basements and properties with high groundwater, we recommend a dual-pump system: a primary submersible at normal operating level and a pedestal backup set two inches higher.
📞 Get a Sump System Quote →
🪟
Window Well Drainage & Egress Window Waterproofing
We excavate and regrade window wells to the proper dimension, install a gravel drain bed with a perforated pipe tied into your perimeter drainage system, and apply waterproof flashing around the window frame — stopping the entry point at the source instead of managing it inside.
Window well covers are a maintenance measure, not a waterproofing solution — but paired with proper drainage installation.
📞 Book a Window Well Assessment →
